← Home About Articles Photos Cycling auf Deutsch Archive Also on Micro.blog
  • This combo of a e*thirteen TRS Plus Gen 2 12-speed cassette paired to a SRAM X01 Eagle derailleur is giving me serious headaches. Shifting is perfect but I can’t get rid of a clicking noise in gear 9 under load. I’m sure it’s the indexing but I can’t get the setting right.

    → 20:44, 3 Jun 2020
  • That wasn’t half bad of a ride yesterday. The last 10 km weren’t pretty but overall I’m happy and not nearly as exhausted as after the 60k ride last Sunday.

    Map of ride 2020-05-31

    → 09:12, 1 Jun 2020
  • The Specialized Power Arc Elaston is on the gravel bike and my Fabric Scoop Pro is on the road bike again. Did a quick shopping ride with the latter and my butt is thankful I removed the Ergon SR Road.

    → 09:16, 30 May 2020
  • The ease of maintenance and customisability of DT Swiss hubs continues to impress me.

    → 12:46, 29 May 2020
  • Ok, I’ve had it with this Ergon saddle; it needs to go. I’m going to move my Fabric saddle from the gravel bike to my road bike and will try out the Specialized Power Arc Pro Elaston. Looking forward to trying it and to a more comfortable saddle on the road bike.

    → 14:58, 26 May 2020
  • I felt good after the ride yesterday but my legs are quite empty today. Huh.

    Map of 25 May 2020 ride

    Himmelreich from above

    → 10:48, 26 May 2020
  • Trying a Garbaruk chainring to reduce chain drop

    Since going 1× on my gravel bike, I’ve had a couple of instances of dropping my chain on quick and bumpy descents. Pelting down a forest road at 50+ km/h, this was quite scary. It was also a bit surprising because the combination of equipment on the bike is supposed eliminate or heavily reduce the chances of dropping the chain:

    • Shimano RD-RX800 clutch rear derailleur
    • e*thirteen XCX Plus 9–39 11-speed cassette
    • Race Face 32-tooth narrow-wide chain ring

    The chain dropping only happened in the 9-tooth cog, which led me to think this might be caused by a lack of chain tension combined with the e*thirteen cassette. I got in touch with the e*thirteen support team and received a really great response, pointing out a number of scenarios and ideas for solving this issue: increasing the B screw tension, shortening the chain by a couple of links, or adding a chain guide.

    Since I a) didn’t want to mess with the B screw too much so as not to degrade shifting performance, b) I sized the chain properly, and c) a chain guide is also out of the question because it would completely ruin – Ruin! I say! – the clean aesthetics of the bike, I looked for a different solution and I think I found it in a Garbaruk chainring.

    Garbaruk builds these chainrings with 40% taller teeth and an overall longer tooth profile, as the two photos below show well, I think:

    Race Face Cinch system 32-tooth chainring

    Garbaruk 32-tooth chainring for Race Face Cinch

    The overall fit of the chain on the chainring is also much tighter and the effect of this has been very positive.

    Since mounting the Garbaruk chainring, I have yet to drop the chain, no matter the situation. I hope it’s going to stay that way and I’m curious how quickly the chainring is going to wear down.

    → 11:46, 23 May 2020
  • Ein Familienmitglied testet aktuell ein elektrifiziertes Delta-Trike von Hase Bikes. Das sind schon echt schöne Maschinen und wahnsinnig gut durchdacht. Bin fast neidisch.

    → 15:51, 21 May 2020
  • Radfahrttipp: "Kurze, harte Schotterrunde"

    Waldweg mit Linkskurve, eingefasst von Bäumen mit einem Grasstreifen in der Mitte

    Ich bin ja immer auf der Suche nach netten Strecken und insbesonndere nach solchen, die sich auf einem Schotterrad (englisch: gravel bike) gut fahren lassen. Verglichen mit Trier und Umgebung, ist hier um Freiburg (im Breisgau) das Netz an so gut wie ununterbrochenen Waldwegen natürlich bedeutend größer und ich erfreue mich schon sehr daran.

    Also fange ich mal an die ein oder andere Runde, die sich bewährt hat, hier einzustellen. Vielleicht findet jemand etwas, dass gefällt.

    Strava

    Komoot

    → 08:23, 18 May 2020
  • First impressions: e*thirteen XCX Plus 11-speed & TRS Plus Gen 2 12-speed cassettes

    The e*thirteen XCX Plus 9–39 11-speed cassette has been on my gravel bike for over a month now and I’ve ridden over 250 km with it so far. It replaced a Shimano XT CS-M8000 11–40 cassette that I’ve ridden for over a year and countless of kilometres. These are my first impressions of the cassette.

    e\*thirteen XCX Plus 9-39 cassette and a Shimano RD-RX800 rear derailleur on a titanium bike

    • Shifting is crisper but a bit more fiddly to set up. I don’t know if it’s the higher number of shift gates or the tooth profile but it took me a while to get shifting right on the bike stand. The cassette would react more quickly to less than optimal indexing. Once tuned properly, I found that it shifts quicker, even under load, and the shift action feels more positive.
    • It’s louder. Not to the point where it annoys me but it took a bit of getting used to. I assume the lightweight construction with the large hollow space amplifies chain noise and shifting sounds.
    • The cassette feels solid and it has yet to show any signs of wear.
    • Chain wrap on the 9-tooth cog doesn’t seem to be an issue. I had read this in a couple of places and was worried that going with such a small cog for the highest gear could cause chain skipping but I’ve not had a problem. Mind you, I’m using a Ultegra RD-RX800 rear derailleur and a Shimano 105 11-speed chain (didn’t want to put on a fresh Ultegra chain, just yet) and I’ve properly adjusted the B-screw tension. Even going full-bore on a flat section, putting as much power as I can into it, hasn’t caused any problems (more on that further down).
    • With the chain on the smallest cog and depending on the chainring used up front (32-tooth and 36-tooth for my bicycles), the chain will be very close to the rear end of the chain stay. Depending on the bike, this may not fit at all. On my Litespeed T5G, I’ve noticed some chain slap going down fast and bumpy descents in the 9-tooth cog, even with a clutch rear derailleur. This is something I’ve never experienced with the 11-tooth cog on the XT cassette and it may be a deal breaker for some.
    • Lastly, and this is not something I’d ever see myself write: it’s noticeably lighter than the cassette it replaced. Sure, ~ 100 g might not sound like much to a less experienced cyclist such as myself but the back wheel seems just a bit more nimble, riding across bumpy gravel tracks.

    All in all I’m happy with the cassette so far. It’s done exactly what I had hoped it would when converting my bike from a 2× 11 to a 1×11 system. With a 32-tooth chainring up front, the 9–39 spread in the back gives me an ample gear range, an easy 0.82 gear ratio in the lowest gear, a reasonably fast 3.55 gear ratio in the highest gear, and fairly tight and even gear spacing, particularly in the higher gears.

    In fact, I’ve been so happy with this piece of kit that I bought an e*thirteen cassette for my city/commuter/road bike that has, up until recently, sported a full SRAM NX Eagle group with a 11–50 cassette and a 32-tooth chainring. I replaced the NX Eagle cassette with the 2nd generation TRS Plus 12-speed 9–46 cassette and the front chainring with a 36-tooth (soon 38-tooth).

    Based on my initial experiences with the 9–39 on my gravel bike, what drew me to the 9–46 12-speed was a) the lower weight, b) the greater range of 511% on the e*thirteen compared to 455% on the NX Eagle, while at the same time offering c) a much tighter and, in my eyes, more sensible gear spacing in the higher gears. The first six gears on the TRS Plus cassette are 9, 10, 12, 14, 16, 18 where on the NX Eagle the jumps are 11, 13, 15, 17, 19, 22. My first road ride with the new cassette was a 45 km trip mostly on the road up a local mountain and then down again and I very quickly appreciated the choices made by e*thirteen.
    Finally, chain wrap on the 9-tooth cog is perfectly fine with a SRAM Eagle rear derailleur and a GX Eagle chain. I tried a couple of times to produce any kind of skipping, riding at 80 rpm, on a slight incline, pushing 42 km/h (yes, I was very much winded after) and I experienced no issues whatsoever.

    I’m looking forward to many more kilometres with these cassettes and I’ll write a long term review at a later point.

    → 11:17, 13 May 2020
← Newer Posts Page 17 of 22 Older Posts →
  • RSS
  • JSON Feed
  • Micro.blog